scuffing

英 [ˈskʌfɪŋ]

美 [ˈskʌfɪŋ]

v.  磨损; 磨坏; 拖着脚走
scuff的现在分词

现在分词：scuffing　

柯林斯词典

• V-ERG (使)磨损;(使)磨坏
  If youscuffsomething or if itscuffs, you mark the surface by scraping it against other things or by scraping other things against it.
  1. Constant wheelchair use will scuff almost any floor surface...
     任何地板上经常有轮椅走动几乎都会有所磨损。
  2. Molded plastic is almost indestructible, but scuffs easily.
     注塑几乎弄不坏，但是容易磨损。
• VERB 拖着脚走
  If youscuffyour feet, you pull them along the ground as you walk.
  1. Polly, bewildered and embarrassed, dropped her head and scuffed her feet.
     波莉既困惑又尴尬，低下头拖着脚走开了。

双语例句

• The coatings has good antifogging property as well as good transparent and resistance to scuffing property.
  实验结果表明，该涂料具有优良的防雾性能，以及优良的透明性和抗擦伤性。
• At the same time, for the power splitting differential gearbox the characteristics of compact structure, according to balanced specific sliding and flash temperature for the planet gear, the parameters of planetary gear can be optimized, gears can improved wear resistance and scuffing resistance.
  同时针对功率分流差动齿轮箱结构紧凑的特点，根据均衡齿轮的滑动率曲线和闪温曲线的研究，优化了行星轮系的齿轮参数，提高了齿轮的抗磨损、抗胶合能力。
• Study on calculating and test method for gear scuffing
  齿轮胶合的计算和试验研究
• The experimental results showed there exists influence of the oil temperature on the scuffing resistant.
  试验结果表明：供油温度对摩擦副的抗咬死性能有较大的影响。
• The temperature effect of scuffing in sliding contact of steel is explored from the point of view of frictional temperature.
  作者从摩擦温度的观点考察了钢在滑动接触中擦伤的温度效应。擦伤试验是在环-块试验机上进行的。
• The mould test demonstrates that the surface scuffing and metal transferring can be greatly deduced at dry friction condition.
  模具试验表明，复合镀层有效地降低了干摩擦状态下注塑模推管与摩擦件的表面划伤与金属转移。
• The working condition and the form of scuffing failure of valve-valve seat pair are introduced. The method of valve-valve seat tribology designing is provided.
  介绍了气门-气门座摩擦副的工作状况和失效形式，提出了气门-气门座摩擦学设计的方法；
• The anti scuffing, friction reducing and wear resistant properties were investigated systematically on a pin on disc tester under engine oil lubrication condition.
  用销盘试验机在机械油润滑条件下对渗硫表面的抗擦伤性能，减摩及耐磨性能进行了系统研究。
• The maximum load on a bearing should always be smaller than the relief load in order to avoid scuffing.
  为了避免划伤，轴承上的最大负荷应该总是小于其卸载负荷。
• The scuffing resistances of three phosphate coatings of manganese are evaluated in a MQ-800 four ball tester equipped with a new wear sample holder.
  在MQ&800四球试验机上装配了一种新的磨损试验夹具，评价了三种磷酸锰盐涂层的抗擦伤性能；