damped

英 [dæmpt]

美 [dæmpt]

v.  弄潮; 使潮湿; 抑制，减弱(感情等)
damp的过去分词和过去式

过去式：damped　过去分词：damped　

GRE

柯林斯词典

• ADJ-GRADED 潮湿的;微湿的;湿气重的
  Something that isdampis slightly wet.
  1. Her hair was still damp...
     她的头发还有点儿湿。
  2. ...the damp, cold air...
     潮湿、阴冷的空气
  3. She wiped the table with a damp cloth.
     她用湿布擦了一下桌子。
• See also:There was damp everywhere and the entire building was in need of rewiring.rising damp
• VERB 使潮湿;弄湿
  If youdampsomething, you make it slightly wet.
  1. Hillsden damped a hand towel and laid it across her forehead.
     希尔斯登沾湿了一条手巾，将它敷在她的额头上。

双语例句

• In this paper the local existence of solutions for a class of strongly damped wave equations is considered, and the global existence and blow-up of solutions based on the potential well theory is studied.
  讨论一类强阻尼波方程解的局部存在性，并利用势井理论研究解的整体存在性和爆破性。
• An efficient numerical method for the finite-element model updating of damped gyroscopic system was developed based on incomplete complex modal measured data.
  提出了一种基于不完备复模态测量数据修正阻尼陀螺系统有限元模型的有效数值方法。
• Simulations on New England test power system show the inter-area oscillation mode damped and the system stability enhanced.
  新英格兰测试系统的仿真结果验证了该方法能有效地阻尼系统的区间振荡模式，提高了系统的稳定性。
• My hope of a better job damped down after six years'waiting.
  经过六年的等待，我想找份好工作的希望淡漠了。
• The nonlinear equations of motion for damping blades were established using the finite element method, and the dynamic response of damped blades were sloved using the harmonic balance method.
  建立了带阻尼结构叶片的有限元非线性动力学方程，采用谐波平衡法对系统动力响应进行了计算。
• This may be damped or undamped forced notion.
  它可以是阻尼强迫运动或非阻尼强迫运动。
• The suspension of the mirrors must be very frictionless, but strongly damped.
  反射镜的悬挂既要无摩擦，但又要有强阻尼。
• The solution of eigenproblem of slightly damped gyro-systems by the direct perturbation method in configuration space;
  导出了在位形空间中，求解对应无阻尼问题有等导重特征值的弱阻尼陀螺特征值问题的直接摄动法。
• A rotor system with flexible damped support has been investigated experimentally under the conditions of simulated blade loss.
  本文对带弹性阻尼支承的转子系统由于丢失叶片产生的瞬态响应给出了系统的实验研究结果。
• Holes are bored in the armature to decrease moving mass and reduce air damped effects.
  设计中在减小运动质量的同时，考虑降低空气阻尼的影响，采取在衔铁上打孔的措施。